A drain stops working for one of a handful of reasons, and the right fix depends on which one it is. Hair and soap in a bathroom sink need a different tool than a grease plug in a kitchen line, and neither is the same problem as tree roots in a 70-year-old sewer lateral. This page walks through the common drain problems in homes across the Kansas City area, how a drain gets cleaned, and how to tell a simple clog from a sign of something deeper.
If water is coming up out of a floor drain, a tub or a toilet right now, skip ahead to what to do first and call. The rest of this page will still be here when the water is gone.
Where drain clogs happen in a house
Every drain in a house runs to the same place, the main drain, and then out to the sewer lateral that leaves the house. Where the problem sits tells you how big the problem is.
One fixture is slow or stopped. If only the kitchen sink or only one bathroom sink is slow, the clog is in that fixture's own trap or the short branch behind it. This is the most common and least serious case. Hair, soap scum and toothpaste build up in bathroom sinks. Grease, coffee grounds and food scraps build up in kitchens.
Tubs and showers. A tub that drains slowly is almost always hair and soap in the trap, often just below the overflow plate. Shower floors with a metal strainer collect the same material. A tub and a shower on the same branch that both back up point further down the line.
Floor drains. Basement floor drains sit at the lowest point of the plumbing system and are connected to the main line. A floor drain that gurgles, smells or backs up when you run the washing machine usually means the main line is partly blocked, not that the floor drain itself is dirty. In older Kansas City homes the floor drain is often the first place a sewer problem shows.
Laundry standpipes. Washing machines push a lot of water quickly. Lint, a collapsed standpipe or a small line can make the standpipe overflow while the rest of the house drains fine.
Several fixtures at once. If the toilet gurgles when the shower drains, or the lowest drain in the house backs up when you run water upstairs, the blockage is in the main line. That is a sewer line cleaning job, covered on the sewer line cleaning page.
The tools: cable, jetter and camera
There are three basic tools, and a good drain cleaning visit often uses more than one.
Hand and drum cables. A cable, often called a snake, is a flexible steel line with a cutting or retrieving head. A small hand cable handles a sink or tub trap. A larger drum machine with a longer cable is used for branch lines and main lines. A cable is fast and works well when the clog is a single soft or solid obstruction, such as a clump of hair or a plug of paper.
Hydro jetting. A jetter sends high-pressure water through a hose and a nozzle that sends jets forward to open the clog and backward to pull the hose along while scouring the pipe wall. It is the better choice when the problem is grease, scale or roots lining the pipe over a long stretch. See hydro jetting for the detail on how it works and when it beats a cable.
Camera. A camera on a flexible rod shows what is inside the pipe. It is how you tell whether a line is clogged, cracked, offset or full of roots, and it is the right step when a clog keeps coming back. More on that at sewer camera inspection.
Snake or jet: how the choice gets made
People often ask which is better. The honest answer is that neither is better in general. A cable punches a hole through a clog. That is perfectly fine for a hairball or a paper plug in an otherwise clean pipe. It is a poor fit when the pipe is lined with grease or mineral scale, because the cable opens a channel about the width of the cutting head and leaves the rest of the buildup in place. That buildup collects new debris and the clog returns.
A jetter works the full circumference of the pipe, so it is the stronger choice for grease, scale, silt and light root growth, and for lines that clog repeatedly. It also costs more per visit than a basic cable, which is why a simple one-fixture clog is not a jetting job. The technician should be able to say why they chose one over the other, and you should expect that explanation.
What causes recurring clogs
A drain that clears and then clogs again within weeks, or months, is telling you something. These are the usual reasons in Kansas City area homes.
- Grease and soap film. Kitchen lines narrow as grease cools and sticks, even if you run hot water afterward. Over time the opening is a fraction of the pipe.
- Tree roots. Roots find the joints in clay tile and cast iron sewer pipes and grow into them. Older neighborhoods with large trees see this often. See tree root removal.
- Belly or sag in the line. Clay soils move. A section of pipe that has settled holds water and debris, and every clog forms in the same spot.
- Scale and corrosion. Old cast iron builds a rough, crusty lining that catches paper and waste.
- Things that should not go down the drain. Wipes sold as flushable, paper towels, feminine products and cooking grease are some of the most common culprits in service calls everywhere.
- Pipe problems. A cracked, collapsed or offset pipe will clog repeatedly no matter how often it is cleaned. A camera finds this.
When to call and when to wait
A single slow fixture that you can fix with a plunger and a few minutes of effort is usually not an emergency. These are the situations where calling sooner is the better call.
- Water backing up out of more than one drain at once.
- A floor drain, tub or toilet that bubbles or overflows when another fixture runs.
- A sewer smell in the basement that comes and goes.
- A clog that returns within a few weeks of the last cleaning.
- A drain that has been slow for months and is getting slower.
- Any backup in a rental unit or a business, where the clock matters.
Chemical drain openers are worth a word. They often do not fully clear a real clog, they sit in the pipe while they work, and they can be hard on older pipes and unsafe for a technician who opens the trap afterward. If you used one, tell the person who comes out.
What a drain cleaning visit looks like
You call and describe what the drain is doing, how long it has been doing it and which fixtures are affected. That information usually tells the technician whether it is a local clog or a main line problem before anyone arrives.
On site, they start with the simplest explanation. They check the fixture, the trap and, for main line symptoms, the cleanout. A cleanout is a capped access point on the sewer line, often in the basement near the foundation wall or outside near the house, and it is the best way to reach a main line without taking apart fixtures. If your house has no accessible cleanout, that is worth knowing, because it makes future cleanings harder.
The technician then picks the tool. A cable clears most one-fixture clogs. A jetter or a camera comes out for lines that clog repeatedly or when the symptoms point to a larger problem. When the line is open, they run water to confirm it drains, and you should be told what was found, whether it is likely to return and what the options are if it does.
You get a quote by phone or at the house. We do not post prices on this site because the work depends on the line, its access and what is in it. Call for a quote.
Preventing the next clog
Most drain problems are preventable, and the steps are not complicated.
- Wipe grease and oil from pans into the trash, not the sink.
- Use a hair catcher in tubs and showers.
- Keep wipes, paper towels and anything labeled flushable out of the toilet.
- Run a kettle of hot, not boiling, water down a kitchen sink once in a while; do not rely on it to dissolve grease.
- Know where your cleanout is and keep it accessible.
- If you have a mature tree near the sewer line, plan on periodic maintenance rather than waiting for a backup.
Houses, rentals and businesses
Houses mostly need one-off cleanings and, where roots or scale are present, a maintenance plan. Rental owners and property managers do better with a regular schedule for the main line, because a backup in a unit costs more than the cleaning. Restaurants and food service businesses are a separate case with grease lines that need frequent attention. See commercial drain jetting for that side of the work.
We serve homes and businesses across the south Kansas City metro, including Kansas City, MO, Overland Park, Olathe, Lee's Summit and the surrounding cities listed on the service areas page.
